How to make a homemade pipe out of a pill bottle

HOW TO MAKE A HOMEMADE PIPE OUT OF A PILL BOTTLE TV

These antennas can be placed indoors to safe guard it from storm and lightning.

Fine-tune the settings and it is ready to be used.

Wind the coaxial cable around the pipe.

Screw it in place with a flat-head screw and washer.

Attach the balun to the two ends of the wire.

Fasten the loose ends of the wire to the PVC pipe.

Ensure the wire doesnвЂ™t touch any two loops on either side.Curl the wire around the rim forming loops.Pass the copper wire through the spoke holes.Prepare a frame putting together the four 12вЂі PVC pipes to form a cross.Start by getting rid of the spokes from the rim.

HOW TO MAKE A HOMEMADE PIPE OUT OF A PILL BOTTLE TV

Connect the antenna to the TV using the coaxial cable and tune your settings.Дesign #3: Using a Bicycle Rim Design #3: Using a Bicycle Rim.

Set up the antenna indoors or outdoors as per your requirement.

Attach the other PVC pipe to this frame using the PVC angle.

Attach the balun to the frame of the antenna.

Fasten the other loose end a little distance away from the first.

Pass it through the last hole and flatten it across the length of the pipe to fasten it to the center.

While forming the sprial ensure that the wires do not come in contact with one another.

Pass it through the holes to form an increasing spiral.

Starting from the fourth hole, curl the wire around the pipe.

Remember to go all the way through to the other side so you can pass the wire through.

Using the drill machine, drill holes in the pipe.

Mark 6 equidistant spots on the pipe each 1.75вЂі apart from the other.

Leave a 2вЂі margin from one end of the pipe and measure 1.75вЂі on the pipe.

Ensure that the wire and the foil do not make contact. In case you wish to use a reflector, cover pieces of cardboard with tin foil and attach to the plank.

Fine-tune the settings and enjoy the show.

Position the antenna to receive signals.

Attach the antenna to the TV through the coaxial cable.

Trim off the sharp edges of the wire hangers to avoid injury.

Secure them into position by fastening the screws and washers.Attach the balun (transformer) to the two phasing copper wires.Insulate the wire where they intersect so that they do not make contact.Before you tighten the screws, pattern the copper wires as shown above.Attach the wires to the board with the help of screws and washers.Ensure that you maintain a distance of 3вЂі between the two ends of the wire.Bend the wire at the center to form a 45 degree angle.Measure the wires and find the mid point of each wire.Straighten out the wire hangers so that you have 4 equal wires.Step #3: Use the wire hangers to create receptors of the antenna Drill holes at the 8 marked points on the plank of wood.You should get 2 rows of equidistant marks.On these lines measure and mark a distance of 5 1/4вЂі from the initial 2вЂі mark.Leave a margin of 1 1/2вЂі from either side of the plank and draw a line across the length of the plank.Start by leaving a 2вЂі space at one end of the plank.Step #2: Measure and mark the plank to be used PVC pipe or stick to hoist the antenna (optional).22вЂі x 8вЂі plank of wood (pine wood is preferred).

How to make a homemade pipe out of a pill bottle